Dimensions; Installation Example; Preparing Electrical Connection; Installing The Electric T-Junction - Franke PR3O0002 Instrucciones De Montaje

8.

Dimensions

9.

Installation Example

10. Preparing Electrical Connection

Materials required
To be provided by the customer:
• Conduit for system cabels
• Damp-room junction box (≥100 mm × ≥100 mm)
Accessories
Function controller
with Ethernet connection
ECC1 . . . . . . . . . . . . . . . . . . . . . . . . . 2000100368
ECC2 . . . . . . . . . . . . . . . . . . . . . . . . . 2000108123
System cable
blue, 100 m . . . . . . . . . . . . . . . . . . . . 2000104272
blue, 25 m . . . . . . . . . . . . . . . . . . . . . 2000104274
gray, not halogen-free, 100 m . . . . . . 2000100801
gray, not halogen-free, 25 m . . . . . . . 2000100852
Terminating resistor . . . . . . . . . . . . . . . 2000100847
Warning!
• Operate the product only with safety extra low voltage (SELV). Do not earth the
components.
• The power supply (ECC function controller, not included in the scope of delivery,
see accessories) must be set up outside of the wet area, in a separate room.
Failure to observe can mean risk of death or material damage, e. g. from electric
shock or fire.
10.1 Install one damp-room junction box (a) for each fitting.
10.2 Lay the system cable (b) through the conduit, and loop it from fitting to fitting.
☞
Let the system cable hang out of the damp-room junction box approx. 50 cm.
10.3 Connect the electric T-junction (c) (see
10.4 Close up the damp-room junction box with the protective cap.

11. Installing the Electric T-junction

☞
Important!
The components of the electric T-junction must be installed only when they are in a
dead condition.
6
info@hygiene-shop.eu - www.hygiene-shop.eu
Order No.
Chapter 11.).