Function; Setting The Range; Setting Hygiene Flushing; Maintenance And Servicing - Franke PR3O0002 Instrucciones De Montaje

13. Function

13.1 Allow your hand to approach the sensor.
• Water flows.
13.2 Remove your hand from the sensor.
• Water flow stops automatically.
☞
Important!
Reflecting surfaces can influence the sensor. There is a risk of having permanent
reflections.
☞
The range of the sensor can be set with the system software.
"Hygiene Flushing" function
Caution!
When the "Hygiene Flushing" function is used, it must be ensured that the water can
flow away properly.
• The "Hygiene Flushing" function ensures that forced flushing takes place to
exchange the water in the branch lines after 24 hours of non-use.
• The "Hygiene Flushing" function can be switched on and off with the system
software or directly on the fitting.
• This function is switched on at the factory.

14. Setting the Range

The signal range can be adjusted with a free program available from Franke.

15. Setting Hygiene Flushing

Hygiene flushing can be adjusted with a free program available from Franke.

16. Maintenance and Servicing

Depending on the quality of the water, the local conditions and the rules and
regulations applicable on site, the fitting must be maintained and serviced at regular
intervals.
Perform maintenance on the following components:
• Aerators (see
• Filters (see
8
Chapter 17.)
Chapter 18.)
info@hygiene-shop.eu - www.hygiene-shop.eu