Moving The Machine - Nussbaum TC 355 Manual De Instrucciones

ENGLISH • Instructions manual
glass (2, Fig. R) to remove any solids collected inside it.
5) If the exagonal arm does not descend as required, it can be adjusted by turning the screw
(1, Fig. R/2):
- turning the screw clockwise increases the descent speed;
- turning the screw anticlockwise reduces the descent speed;
N.B.: This adjustment is important when working on alloy rims that could be damaged if the
head descends rapidly.
1
R/2

13. MOVING THE MACHINE

Follow the procedures outlined below when moving the machine:
1) Close the turntable grippers all the way towards the centre.
2) Turn the table so that the its straight sides are lined up the projected line of the
side panels (See Fig. S/1).
3) Disconnect all power sources.
4) Clamp the pedal (7, Fig. L) with a wedge underneath it.
S/1
5) Remove the horizontal arm casing by unscrewing the fixing nuts (1, Fig. S/2).
6) Move the horizontal arm (11, Fig. L) all the way back.
7) Sling the machine with lifting straps at least 60 mm wide.
8) Pass the first strap behind the horizontal arm as shown in Fig. S/3.
9) Pass the second strap between the two front slots on the turntable plate as shown
1
in Fig. S/1.
S/2
10) Gather the ends of the slings in a suitable ring above the machine (see Fig. S/4).
11) Hoist and move the ma-
chine with a sufficiently strong
lift truck.
S/3 S/4
TC 355 - Liga C 253
35