General Instructions; Inserting Batteries - LaserLiner ThermoMaster Plus Manual De Instrucciones

Symbols
Warning about hazardous electrical
voltage: Unprotected live components
inside the device housing are capable
of posing a risk of electric shock.
Danger area warning

General instructions

– If the thermometer is subject to large fluctuations in the ambient temperature, after the temperature
has stabilised, wait 20 minutes before performing a measurement.
– Always ensure adequate thermal coupling at the measuring point in order to avoid measuring errors
caused by temperature loss.
– Please note that all thermometers with a contact sensor influence the measurement and their
thermal capacity can reduce the actual temperature. More thermal energy should therefore be applied
to the thermocouple than it can dissipate.
– Four lines will appear in line A if no thermocouple is connected.
– Lo or Hi will be displayed if the measured temperature is outside the measuring range.
– Only use the correct type of thermocouple (type K, J, T or E) and make sure that the device is set
to the corresponding type. The wrong type can cause significant measuring errors.
– In addition to being subject to ageing, a thermocouple is also greatly depending on the operating
conditions and should therefore be checked regularly.
– High pressure or mechanical deformation can change the grid structure and therefore have an influence
on the thermoelectric voltage output.
– The thermometer and thermocouples have different measuring ranges and accuracies and therefore
need to be considered separately.

Inserting batteries

1
Open the battery com-
partment and insert
batteries according
to the symbols.
Be sure to pay
attention to polarity.
Connecting thermocouples
2
ThermoMaster Plus
Batteries:
6.0V
!
(4 x 1.5V AAA)
Pay attention to the polarity information on the
A quality product from
GmbH & Co. KG
Donnerfeld 2, 59757 Arnsberg
Germany, Tel.: +49 2932 638-300
Fax: -333, www.laserliner.com
thermocouple as well as on the device connection.
ThermoMaster Plus
Protection class II: The test device
has reinforced or double insulation.
Earth potential
Read operating instructions
T2 T1
13
EN