LaserLiner ThermoMaster Manual De Instrucciones página 8

12 13
11
10
9
8
14 15
3
ON/OFF
4 Temperature measurement (T1, T2, T1-T2)
The temperature T1 or T2 is measured and displayed by pressing button „T1"
or „T2". A thermocouple (type K) must be plugged in at connection T1 or T2.
The differential temperature can be determined by pressing button „T1-T2"
when thermocouples are plugged in at both connections.
5
MAX-/HOLD function
The maximum temperature in an extended series of measurements is determined by pressing the „MAX"
button. The HOLD function shows the last measurement or measured value in the display.
08 GB
1 LC display, 3.5 segments,
max. 1999
2 ON/OFF
3 Degrees Celsius
4 Hold current measured value
1
5 Degrees Fahrenheit
6 Temperature K-type input T2
2
7 Differential temperature
K-type input T1-T2
3
8 Temperature K-type input T1
4
9 Measured value resolution
5
10 MAX value
6 11 Display illumination
7
12 1/4" tripod connection
13 Battery compartment
14 K-type input T2
15 K-type input T1
d
c
a Units:
Degrees Celsius/Fahrenheit
b Measured value
c Negative measured value
d MAX value
e Hold current measured value
f Temperature K-type input T1
g Temperature K-type input T2
h Differential temperature K-
type input T1-T2
This display appears when no corresponding
thermocouple is connected or the measuring
range has been exceeded.
e f g h
a
b