Fermax VIDEO CITYLINE DUOX 1L Manual De Instalador página 49

DUO DUO DUOX CITYLINE KIT 1-2L DUO DUO X CITYLINE KIT 1-2L X CITYLINE KIT 1-2L X CITYLINE KIT 1-2L X CITYLINE KIT 1-2L
DUO DUO X CITYLINE KIT 1-2L X CITYLINE KIT 1-2L
DUO DUO DUOX CITYLINE KIT 1-2L X CITYLINE KIT 1-2L X CITYLINE KIT 1-2L
The selected option is displayed with the white line under the icon. Press and a screen
appears confirming the selected option (image of a face) and a beep sounds on the
monitor.
The monitor will automatically connect with the entry panel, activating the camera. Enter
the calling code for this monitor from the panel. Depending on the type of panel installed:
- pressing the corresponding button or
- by entering the code + bell.
Notes:
- The time between selecting the programming option
the button is pressed on the entry panel must be less than 2 and half minutes.
- Programming is always done from the panel activated as the master panel.
2222
F1
MENU
A different call tone is produced, confirming the monitor's programming and the camera's
image is still viewed.
Option 2: From the Monitor Monitors can be programmed on the screen menu.
Program the call number: Press  on the previous screen and access the screen to
program the residence's number (numbers from right to left).
Each time the + is pressed the number increases (starting with 1) and the arrow is used
for moving the cursor. A white cursor indicates where the digit will be entered. Program the
corresponding number and accept with .
After a few seconds the monitor returns to standby.
from the Panel + Monitor until
Page 17