Orbegozo DS 76190 BL Manual De Instrucciones página 14

DS 76190 BL/N
NOTICE OF INSTALLATION
• Before installation, please ensure the area is clean to avoid suction of the remaining bits of broken wood
and dust.
• It cannot share the same air ventilation tube with other appliance such as gas tube, warmer tube, and
hot wind tube.
• The bending of ventilation tube should be≥120°, parallel or above the start point and should be
connected to the external wall.
• After installation, make sure that the extractor is level to avoid grease collection at one end.
USE OF CONTROL PANEL
1. Press the "POWER" button, to turn on and turn off the motor.
2. Press the "SPEED" button, the speed will pass from low to middle and high. LED display will indicate 1, 2
and 3 circularly.
3. Press "LIGHT" button to switch on the light and press it again to switch off the light.
4. When the hood is working, if you press "TIMER" button, the hood will go into the status of acquiescent
working (acquiescent time is 9 min) and then, the LED display will indicate as "9-8-7...-1-0", when it
indicates "0", the hood will be off automatically. If you press "TIMER" button before turn off you will stop
timer function.
MAINTENANCE
1 The cleaning of the grease filter mesh
The filter mesh is made of high-density stainless steel. Please do not use the corrosive detergent on it.
Keeping this filter clean will keep the appliance running correctly. Please strictly follow the guidelines below.
Method 1: Put the mesh into 40-50 c clean water, pour on detergent, and soak for 2-3 mins. Wear gloves
and clean with a soft brush. Please do not apply too much pressure, as the mesh is delicate and will damage
easy.
Method 2: If instructed to do so, it can be put into a dishwasher, set the temperature at around 60 degrees.
Speed adjustment .See pictures
LED touch button
14