Installation Instructions; Before Installation; Electrical Installation; After Installation - Teka MWR 32 BI Manual De Instrucciones

Installation instructions

Before installation

Check that the input voltage indicated on the
characteristics plate is the same as the voltage of the
power outlet you are going to use.
Open the oven door and take out all the accessories
and remove the packing material, including the white
polystyrene part that holds the turntable plate.
Do not remove the mica cover on the ceiling of the
interior! This cover stops fat and pieces of food
damaging the microwave generator.
Warning! The front surface of the oven may be
wrapped with a protective film. Before using the oven
for the first time, carefully remove this film, starting on
the inside.
Make sure that the oven is not damaged in any
way. Check that the oven door closes correctly and
that the interior of the door and the front of the oven
opening are not damaged. If you find any damage
contact the Technical Assistance Service.
DO NOT USE THE OVEN if the power cable or the
plug are damaged, if the oven does not function
correctly or if it has been damaged or dropped.
Contact the Technical Assistance Service.
Put the oven on a flat and stable surface. The oven
must not be put close to any sources of heat, radios or
televisions.
During installation, make sure that the power cable
does not come into contact with any moisture or
objects with sharp edges behind the oven. High
temperatures can damage the cable.
Warning: after the oven is installed you must make
sure you can access the plug.

Electrical Installation

Electrical installation must be performed by an
electrician qualified in accordance with the legislation
in force.
Before connecting the microwave oven to the electric
mains, check that the voltage and frequency of the
mains matches that which is shown on the rating plate
located in the cavity front, and on the guarantee
certificate, which should be kept together with this
manual.
During installation, follow the instructions supplied separately.
The electric connection is made via plug (where
accessible) or via an omnipolar switch, which is
suitable for the intensity to be tolerated and which has
a minimum gap of 3mm between its contacts, to
ensure disconnection in case of emergency or when
cleaning the microwave.
The connection should include correct earthing, in
compliance with current norms. WARNING: THE
OVEN MUST BE EARTHED.
If the flexible supply cable fitted to the microwave ever
needs to be changed, it should be replaced by an
official After Sales Service, because it requires special
tools.
The manufacturer and retailers do not accept
responsibility for any damage that may be caused to
people, animals or property if these installation
instructions are not observed.

After installation

The oven only functions when the door is closed
correctly.
Before the first use, clean the inside of the oven and the
accessories, following the cleaning instructions given in
the section "Oven cleaning and maintenance".
Fit the Turntable support in the centre of the oven cavity
and put the Turntable ring and the Turntable plate on top,
making sure they slot in. Whenever you use the
microwave, the turntable plate and the respective
accessories must be inside and correctly fitted. The
turntable plate can rotate in both directions.
EN
4