General Information; Operation And Controls; Before Using For The First Time; Preparing The Appliance For Use - Princess Lotte Juicer Serie Instrucciones De Uso

General information

This Princess Lotte Juicer is ideal for
quickly pressing a wide variety of citrus
fruits. This attractively designed appliance
is a welcome addition in every kitchen.
With the two pressing cones supplied you
can press both large and small citrus fruit
with the greatest of ease. The juice drips
directly into an attractively designed jug
that you can take straight to the table.
Operation and
controls
See figure 1.
The appliance includes the following
components:
1 Motor unit
2 Drip stop control
3 Large pressing cone
4 Small pressing cone
5 Pulp compartment
6 Juicer jug lid
7 Motor unit lid
8 Juicer jug

Before using for the first time

• Make sure that the mains voltage is
the same as that indicated on the type
plate on the appliance.
1 Remove all packaging materials and
stickers from the appliance.
2 Clean the appliance and all the
accessories (see 'Maintenance and
cleaning').

Preparing the appliance for use

• Do not use the juicer without the juicer
jug.
4 Lotte Juicer Article 202000
1 Put the juicer jug on a flat, stable
surface where it cannot fall.
2 Place the motor unit on the juicer jug.
Ensure that the juicer jug pushes the
drip stop control fully in.
3 Place the pulp compartment in the
motor unit.
4 Place the small pressing cone in the
pulp compartment opening. This is
used to press small citrus fruits (such
as lemons).
5 Place the large pressing cone over the
small one. Using the large pressing
cone you can press larger citrus fruits
(such as grapefruit).
6 Put the plug into the wall socket.
Use
1 Cut a citrus fruit in half.
2 Place the cut surface of one half on the
pressing cone.
3 Press the fruit downwards. With the
pressure the juicer switches on and the
fruit is pressed. The juice flows
automatically into the juicer jug.
4 Press the fruit until hardly any more
juice comes out. When you release the
pressure, the appliance stops turning.
5 Press the fruit downwards once more.
The pressing cone may turn in the other
direction.
Note:
The motor automatically changes
directions when it is switched on and off.
This is normal and this increases the
amount of juice.
6 Stop pressing when no more juice
comes out, or when the juicer jug is full.
Check the level indicator on the juicer
jug at regular intervals.
Note:
To prevent the appliance from overheating
you will need to allow it to cool for around 5
minutes after every 10 pressings.
7 Lift the motor unit off the juicer jug. The
drip stop system will prevent any more
juice flowing out of the reservoir. The