Imetec N5001 Instrucciones De Uso página 26

EN
Only a little steam
or none at all is
dispensed.
The impurities that
come out
from the steam holes
stain the garments.
Impurities or pieces of
limescale emerge from
the plate.
Water leaks from the
plate.
The 4 temperature
setting lights flash
simultaneously, and the
iron doesn't work.
All 8 lights flash
simultaneously, and the
iron doesn't work.
22
There is not enough water in
the reservoir (3).
The anti-scale filter (14) is no
longer effective.
The anti-scale filter (14) is not
inserted correctly.
Chemical additives, scented
liquids or descaling agents are
being used.
Starch is being used.
Possible limescale residue
inside the iron.
Plate temperature (16) too
low due to pressing the
steam request button (17) too
frequently.
The temperature adjustment
knob (13) is set to a
temperature that is too low.
The steam adjustment knob
(10) is not positioned on the
setting matching the one
selected with the temperature
adjustment knob (13).
Type 1 flaw in the electronic
temperature reading system.
Type 2 flaw in the electronic
temperature reading system.
Fill the reservoir (3).
When the anti-scale filter (14) is no longer
effective, the electronic system modifies
steam emission to safeguard the lifespan
of the product.
Check the filter change indicator light
(8) and the acoustic signal are ON, then
replace the filter as explained in the
specific paragraph.
Cross-check the anti-scale filter insertion
process as indicated in the specific
paragraph.
These substances damage the product:
do not add additives to the water in the
reservoir.
Always spray the starch on the reverse
side of the fabric.
Use a damp cloth to remove the impurities
that have deposited on the plate.
Allow slightly longer intervals between the
jets of steam.
Turn the temperature adjustment knob
(13) into a position from 2 dots upwards.
Turn the steam control knob (10) to the
setting matching the one selected with the
temperature adjustment knob (13).
Switch off and then back on again. If
the problem persists, contact Customer
Support.
Switch off and then back on again. If
the problem persists, contact Customer
Support.