Metabo TNS 150 W Instrucciones De Servicio página 12

10
Undo the hexagon nut (1) on the wet grinding wheel.
Remove all parts from the rotary shaft. The rear clamping
flange (5) remains on the rotary shaft. Clean the two
clamping flanges and carry out a sound test (Fig.8) on
the new grinding wheel.
Reattach the new grinding wheel as described above,
but in reverse order.
1
2
3
4
5
11
1 Hexagon nut (standard right hand thread)
2 Washer or split washer
3 Front clamping flange*
4 Wet grinding wheel
5 Rear clamping flange
*not required with all TN models.
Specifications
Power supply
Motor power P
1
No-load speed
Grinding wheel Ø
Grinding wheel width
Machine noise information: workplace sound pressure L p level below 80 dB(A).
TNS 150 TNS 175 W
1 ~ 230 V 1 ~ 230 V
330 W 450 W
2750/126 min -1 2750/126 min
150/200 mm 175/200 mm
20/40 mm 25/40 mm
Cleaning
Caution! Always pull out the plug prior to cleaning!
Every now and then clean the outside of the grinding
machine with a damp cloth.
Make sure to clean the inside of the grinding wheel
casing. The grinding wheels must always be able to run
smoothly within the casing.
Cleaning the water container
Remove the water container as often as possible and
clean it from the inside using water and a brush (no metal
brushes!).
Connection to Power Mains
black
schwarz
red
rot
3 ~ 400 V / 50 Hz
L1
L2
L3
PE
U1 V1
TNS 175 D
3 ~ 400 V
570 W
-1 2600/126 min -1
175/200 mm
25/40 mm
12
L1
PE 1~230 V / 50 Hz
N
U1 Z1
Ha Hi
Z2
U2
red yellow
rot gelb
C
W1
Drehstrom-
Three phase
typen:
current type:
SL 175 D
M TNS 175 D
SL 200 D
3~
Wechselstrom-
Single-phase
typen:
models:
DS 125 W
TNS 150 W
DS 150 W
TNS 175 W
DS 175 W