Abbreviations And Terminology; Important Notes; Technical Specifications - Franke AQUAMIX 76 12982 000492 Instrucciones De Montaje

2.

Abbreviations and terminology

TWW
TW
SW
DN
FAR Order No.
EA No.
Conversion
All length specifications in the graphics are in mm.
3.

Important notes

• Installation, commissioning and maintenance are to be performed only by a qualified
technician according to the instructions provided.
• Legal requirements and the technical connection regulations of the local water supply
companies must be complied with.
• Before assembling and installing the equipment, flush the supply pipes in accordance
with DIN 1988!
• Only operate this valve in conjunction with the correct grit filters.
• If the temperature of the hot water supply is above 45 °C, the temperature limiter
must be set to prevent scalding (see
• Use suitable cleaning agents that are not harmful to the fittings in a proper manner
and rinse with water after use. High-pressure cleaners must not be used for cleaning.
• All rights reserved to make technical alterations.
4.

Technical specifications

Minimum flow pressure
Calculation flow rate
Volume flow 2152 00 23
Volume flow 2154 00 23
Flow time at 38 °C
4
Warm drinking-water
Drinking-water
Width A/F
Nominal diameter in mm
Franke-AQUAROTTER Order No.
European article number
1 mm = 0.03937 inches
1 inch = 25.4 mm
Chapter 11.).
1.0 bar
TW 0.07 l/s (4.2 l/min), TWW 0.07 l/s (4.2 l/min)
0.10 l/s (6 l/min) at 3 bar flow pressure
0.13 l/s (7.8 l/min) at 3 bar flow pressure
1 – 30 s adjustable