Adjusting The Temperature; Replacing The Functional Part; Swivel Limit (Model With A Swivel Outlet) - Franke AQUAMIX 76 12982 000492 Instrucciones De Montaje

– shorter flow time (min. 1 s)
10.6 To measure the flow time, trigger water flow from the fitting by pressing the handle jack.
10.7 After setting the required flow time, replace the push-cap handle.
☞
Important!!
When refitting the push-cap handle, ensure that the attachment rib locks in the
appropriate groove.

11. Adjusting the temperature

11.1 Remove the push-cap handle (see
11.2 Use a screwdriver to carefully prise off the stop ring and then use your hand to pull it off
from the teeth.
11.3 Mount the push-cap handle and trigger the fitting.
11.4 Turn the push-cap handle until the desired maximum hot-water temperature is reached.
11.5 Push the stop ring back on the teeth so that the nose of the stop ring is positioned up
against the right-hand stop of the housing.
11.6 Reassemble in the reverse order.
☞
Important!!
While fitting the push-cap handle, make sure that the driving lug locks properly into the
corresponding groove.

12. Replacing the functional part

12.1 Close both water flow volume regulators (see
12.2 Drain the fitting (see
12.3 Remove the push-cap handle (see
12.4 Pull off the circlip.
12.5 Remove the circlip, the handle jack and the pressure spring.
12.6 Use a socket spanner to remove the functional part.
12.7 Reassemble in the reverse order.
☞
Important!!
When refitting the push-cap handle, ensure that the attachment rib locks in the
appropriate groove.

13. Swivel limit (model with a swivel outlet)

Depending on the position in which the stop ring is fitted (see diagram), the swivel arm
can be either fixed in a rigid position or it can be moved within a swivel range of 150°.
If the stop ring is removed, the swivel arm could theoretically be rotated through 360°.
6
Chapter
Chapter 14.2).
Chapter
10.).
Chapter 14.1).
10.).