Fitting The Wheels - Peg-Perego triplette sw Instrucciones De Uso

EN_English
Thank you for choosing a Peg-Pérego product.
WARNING
_ IMPORTANT: read the instructions carefully before use and keep them for future
reference. The child may be hurt if you do not follow these instructions.
_ This item was designed for the transport of 3 children in the seats.
_ Do not use this item for a number of occupants greater than that intended by the
manufacturer.
_ This item was designed for use in combination with the following Peg Perego Ganciomatic
products: the "Seat Unit" carrying chair - the "Primo Viaggio" car seat (Group 0+).
_ Before use check that the Peg Perego Ganciomatic products are correctly fixed to the item.
_ The assembly and preparation of the item must be carried out by an adult.
_ Do not use this item if there are parts missing or signs of breakage.
_ It may be dangerous to leave your child unattended.
_ Always apply the brake when stationary.
_ Before use check that all the attachment mechanisms are correctly engaged.
_ Do not insert fingers into the mechanisms.
_ Be careful not to hurt the child when adjusting the mechanisms (handlebar, backrest).
_ Any weights hanging on the handlebar or handles could make the item unstable; follow the
manufacturer's instructions as regards the maximum loads transportable.
_ Do not load the baskets over 5 kg. Do not put weight in the cup holder in excess of those
indicated on the cup holders themselves and never hot drinks. Do not put loads of more
than 0.2 kg in the hood pockets (if present).
_ Do not use the item near to stairs or steps, heat sources, naked flames or dangerous
objects within reach of the child.
_ The use of accessories not approved by the manufacturer could be dangerous.
_ This item is not suitable for jogging or roller skating.
_ Apply the brake when loading or unloading children.
INSTRUCTIONS
1 FITTING THE WHEELS: remove the four protective caps, (two round and two square) from
the folded chassis, as in the figure.
2 WARNING: distinguish the front wheels (Fig. A) from the rear wheels (Fig. B), as in the
figure.
3 Fit the front wheels, which are shown in Figure A, while the base is closed. It is necessary
to push the locking lever down (fig. B) and at the same time push the hub onto the pin (fig.
C). Check that the wheels are properly attached by pulling them in opposite directions.
4 To fit the rear wheels, repeat the action carried out for the front wheels (sequence B and C).
The rear wheels can be identified by the black teeth, as shown in figure A. Check that the
wheels are properly attached by pulling them in opposite directions.
5 BRAKE: to activate the brake on the chassis, push down with your foot on the brake bar
located on the rear wheels, as shown by the arrows in the figure.
6 OPENING: activate the brake on the folded chassis. Unfasten the tab, as in the figure.