Master Coffee Serie Manual De Instrucciones página 10

zone 1 and zone 2; in zone 3 the minimum above ground level is
180 cm, according with the rules of each Country.
Be sure that the heater is not facing the ceiling or inflammable
•
substances.
The appliance must not be located neither directly below, nor in
•
front of a socket-outlet.
The heater must be installed so as to prevent that the switches can
•
be touched from those who are in the shower.
Ensure that there is no possibility of inflammable material, com-
•
bustible material or curtains coming into contact with the heater,
or lie near the heater.
Heaters should not be installed in areas where hazardous vapours
•
may be present. Defined in BS5345.
The heaters are fitted with safety guards. These are intended only
•
to stop large objects from hitting the emitters. On no account
should the heater be operated with the guard removed.
For consumer use the heaters are fitted with high temperaure sili-
•
cone rubber flexible cable (H05 RN-F) conforming to BS 6500.
The models for professional use, that are marked with a "P" in the
•
code, do not have the power cord and the switch. For professional
installation, cabling of the same specification should be selected.
The product is in class I and IP65, wich is the protection rate for
•
the units to be used even outdoor. For keeping the protection rate
of the appliance, the connection of the appliance with the power
supply must be done by means of a minimum IP65 system, as per
the standards HD 384 CENELEC for Europe, or international IEC
60346-7-708 1988.
Before pressing the switch, seize firmly the grip and avoid to touch
•
the metal parts.
3. LOCATION
The Coffee range of heaters is deliberately designed to be very flex-
ible in the choice of position. There are three basic options:
A wall mounting bracket version with a specifically designed
•
fitting for wall attachment (4165.786). Before drilling the holes
for the dowels, be sure that the wall is solid and that you are far
from water tubes or electrical wires. Apply the drilling template
10