Oster BLSTDP-W00 Manual De Instrucciones página 12

BEFORE USING YOUR BLENDER
After unpacking the blender, wash everything except the blender base in warm, soapy
water. Dry thoroughly. Wipe the blender base with a damp cloth or sponge. Do not
immerse the base in water. Care should be taken when handling the blades, as they are
very sharp.
HOW TO ASSEMBLE AND USE
I
mportant: Your blender jar and cutting blades are subject
to wear during normal use. Always inspect cutting blades
for broken, cracked or loose blades. If jar or cutting blades
are damaged, do not use.
• Make sure blender is unplugged. Place blender base on
clean, dry surface to keep foreign particles from being
pulled up into motor during operation.
• Before inserting blade assembly, be sure that the gasket
is seated around blade base.
• Insert blade assembly onto the bottom opening of the jar.
Tilt the blade slightly to properly insert it.
• Place the bottom cap by screwing it clockwise onto the jar
bottom until tight.
• Place the jar on the motor base, ensuring a tight fit.
• Plug cord into outlet.
• Put ingredients in jar, place lid on jar making sure it is
pushed down completely into position.
• Process food or beverages. Place hand on lid when
blending liquids. Select the desired function on the con-
trol panel to start blending, please refer to the "Use of the
Special Features of Your Blender" section for operating
instructions.
• Always turn blender off or wait until it shuts off
automatically and blades have stopped rotating before
removing jar or lid.
• Remove jar after blending is complete by lifting it from
motor base.
• Never place jar onto unit while motor is running.
• Never run empty.
• Never run without jar.
• Your blender jar was designed with a stable base and a lid with snap-open spout for
easy serving.
En g lish-4
Figure 1
Figure 2