Factory Default; Alarm Screens - Roxell RDC Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 130
Over Shoot Average is the average batch overshoot for females feeding (in Kg/Lb)
Over Shoot Counter is the number of female batches given.
Auger 1 Speed is the calculated speed of the female auger (in Qtr Seconds to 1 Day Bin
CDP change times 10)
Auger 1 Speed is the calculated speed of the male auger (in Qtr Seconds to 1 Day Bin
CDP change times 10)

Factory Default

To reset all parameters to the factory default enter here the code 19501.

9.0 Alarm Screens

When an alarm occurs, the alarm relay changes state from NO contact to NC contact and
the state of the RDC is changed accordingly. The alarm type will appear in the Alarm
screen. To clear a alarm, press on the Alarm shortcut key, then press on the „0‟ key (in
this case there is no need to press on the Prog key or the Enter key). After clearing the
alarm, the RDC will return to the state that it was in before the alarm occurred.
If there is another alarm, repeat the above steps.
For a description of the different types of alarms and their possible causes, see the Alarm
table on page 24.
Roxell Daybin Controller – RDC
Diagnostic 5
OvSHAverage:
OvSHCounter:
Diagnostic 6
Auger 1 Speed: 1.5
Auger 2 Speed: 1.6
Factory Default
Enter Code:
Silo – Weight
Press 0 to Clear
Page 20 of 193
5
35
0

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

04907259

Tabla de contenido