Load Cell, Joint Unit And Base - Roxell RDC Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 130
Connect the load cell to the base as shown below. Tighten down the bolts.
Be sure the arrow on the side of the load cell is pointing down
Load Cell connected to base unit
Connect the Joint unit to the load cell. Screw the Joint unit down until it is flush with the
bottom side of the load cell.
Tighten the Lower joint nut to secure the Joint unit to the load cell.

Load cell, joint unit and base

Next place the Upper Channel plate on the Joint unit as seen below.
Upper Channel
Plate
Joint unit
Load cell
Base
After all 4 silo mount leg hardware have been assembled and fasten to the concrete floor,
slowly lower the silo onto the silo mount.
Roxell Daybin Controller – RDC
Joint
unit
Joint unit
nut
Page 28 of 193
Arrow must point down

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

04907259

Tabla de contenido