Silo States - Roxell RDC Manual Del Usuario

Silo States

Silo state
Normal
Fill Detect
Cal-Zero
Cal-Weight
Cal Exit
Cal Error!
CDP Error!
Setup Error
Roxell Daybin Controller – RDC
Description
The silo is in a idle state.
The RDC has detected an increase in the
silo weight of at least 50 Kg (110 Lb). Any
increase less than 300 Kg (660 Lb) will not
be registered as a feed silo fill (see Silo
status screen on page 10).
The silo is in the Zero calibration state
(page 16)
The silo is in the Weight calibration state
(page 16)
The RDC will exit this state 10 seconds
after the calibration process is finished.
The calibration process failed. Redo
calibration.
No CDP data from SILO A/D box (weight
appears -----).
No jumper has been put on SILO2 in SILO
A/D box.
Page 25 of 193