GB
IMPORTANT SAFETY INSTRUCTIONS
CAUTION: Read and follow all instructions before operating
this fan.
Use the fan only as described in this manual. Misuse may cause a fire or
an electrical shock.
1.
Do not operate the fan with a damaged cord or plug, after the
fan malfunctions, has been dropped or damaged.
2.
Close supervision is necessary when this fan is used near children,
the elderly and pets.
3.
Always turn the fan off after use, before cleaning, or moving
location.
4.
Do not insert fingers or other objects into the fan guard.
5.
Do not operate the fan in areas where petrol, paint or other
flammable liquids are used or stored.
6.
Do not place the fan near an open flame, cooking or heating
appliance, or hot surface.
7.
This fan is not intended for use in wet or damp locations. Never
locate the fan in an area where it may fall into a bath or other water
container.
8.
Always use on a dry, level surface.
9.
Do not let the power cord hang over the edge of a table or counter.
10. Arrange the cord away from an area where it may be tripped over.
11. Never place the power cord under a carpet or rug.
12. To disconnect from the power supply, grip the plug and pull from the
power socket. Never pull by the cord.
13. This fan should not be operated outside.
14. Do not hang or mount the fan on a wall or ceiling.
15. Do not operate without fan guard properly in place.
16. If the power cord is damaged, it must be replaced by the
manufacturer or a qualified service engineer to avoid any risks to
safety.
Item
Model
Size
Dimension
IP
Voltage
Low
220-240 V/50Hz
High
OPERATING INSTRUCTION
To adjust airflow upward or downward: Tilt the fan head to the desired
angle by hand easily
Speed Control: Rotate SWITCH to LOW, or HIGH speeds for respective
air velocity.
1. After continuous operation, it is normal for the motor to feel warm
when touched.
2. This fan features an overheat safety cut-out device, which will
automatically shut the fan off should it overheat for any reason. If
this happens immediately unplug the fan from the power socket.
MAINTENANCE
1. Before cleaning turn the fan off and unplug from the power supply.
2. To clean the fan use a soft cloth to wipe off any dust. If the fan is
very dirty use a damp cloth and wipe dry. Do not use any cleaning
detergents, sprays or other chemicals, as they will damage the
plastic.
3. Store the fan in the original packaging in a ventilated dry area.
4. The motor bearings are permanently sealed and do not require
additional lubrication.
WANRING
Do not operate the fan with a damaged cord or plug, after the fan
malfunctions, has been dropped or damaged.
Do not use extension cords with this product!
To reduce the risk of fire or electrical shock, do not use the product with
a solid state speed control device.
Caution:
Automatically operated device-To reduce the risk of injury disconnect
from power supply before servicing.
This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safety. Children should be supervised to ensure that they do not
play with the appliance.
SPECIFICATION
30" Tilted Drum Fan
DF 30 P
30"/750 mm
910x330x935 mm
20
Watts
Current
[W]
[A]
395
1.64
465
1.93
Speed
Air Vol.
3
[RPM]
[m
/min]
1200
253
1300
280