Yakima LANDING PAD 10 Manual De Instrucciones página 3

Using the included wrench, tighten special nuts completely.
• Pull rear side of base
toward you as you
tighten the special nuts
as shown.
• Make sure bases are
fitting tightly into track.
REAd thESE wARningS!
Make sure SkyLine or Control
Towers, with bars installed,
seat completely with Landing
Pad. If they do not seat
properly, repeat step 6 with
special attention to pulling rear
side of landing pad toward you
as you tighten the special nuts.
Continue with SkyLine or Control Tower installation.
1033434C-3/9
Tighten Rear first,
then tighten the front.
Be sure all hardware is secured
according to instructions. Failure to
perform safety checks before driving
away can result in property damage,
personal injury, or death.
Attachment hardware can loosen over
time. Check and tighten if necessary,
before each use.
pULL
• do not EXCEEd wEight limit:
165 lbs. (75 kg)
• Consult your YAKimA dealer or
fit list to see load limitations for
accessories.
Remove your YAKIMA rack and
accessories before entering automatic car
washes.