Parts And Components; Before Use; Operation - cecotec POWER TITANIUM 500 FRESH&GO Manual De Instrucciones

ENGLISH

2. PARTS AND COMPONENTS

Fig.
1. Lid x2
2.
Bottle x2
3.
Blades
4. Main body
5. Cooling tube x2

3. BEFORE USE

Take the product out of the box.
Remove any packaging materials, stickers or protective foil from the soleplate.
Do not use the appliance if it is visibly damaged. If it is, contact the official Technical Support
Service of Cecotec.
Wash and dry the blender and its accessories carefully before use. Then, place the blender on
an even, firm and dry surface.

4. OPERATION

Fill the cooling tubes with water up to the mark in their Surface. Put them in the freezer for
12-24 hours.
Introduce the ingredients in the bottle. Make sure the ingredients do not exceed the 600-ml
mark on the surface. Close the bottle with the blade assembly and turn it upside down.
Warning: Make sure the cooling tubes are not inside the blender before starting blending.
They can only be placed inside the bottle once ingredients have been processed.
Connect the device to a power supply and fit the bottle onto the main body. Press the bottle
and turn it slightly clockwise to lock it into place.
Press the button on the appliance to blend the foodstuffs.
Note: Do not use the appliance for more than 1 minute without pauses and allow a 2minute
rest between uses.
Turn the bottle counterclockwise to unlock and remove it from the appliance's main body.
Unscrew the blade assembly, screw the cooling tube onto the bottle's lid and then close the
bottle.
Unplug the appliance.
Note: The appliance could block when overfilled. Should that happen: turn it off, unplug it and
remove pour some of its contents out. Then, try again.
14 POWER TITANIUM 500 FRESH&GO
Power Titanium 500 Fresh&Go.indd 14 15/11/19 11:55