Troubleshooting - cecotec Conga 1590 Active Manual De Instrucciones

CLEANING MAIN BRUSH KIT
• Remove the main brush kit from the product's main body, separate the cover from
the brush and clean them separately.
• The brush can be washed in soap and water.
WARNING: Do not introduce the main brush back in its place unless it is completely dry.
BATTERY REMOVAL AND REPLACEMENT
1. Remove the screws on the battery cover with a screw driver.
2. Remove the battery cover.
3. Remove the insulating tape on both sides of the battery and take it out.
4. Unplug the wire connector that links the battery and the robot.
5. Introduce the new battery and make sure the side with printed words is facing upwards.
6. Connect the cable from the battery to the robot.
7. Introduce the battery into the compartment.
8. Screw back the battery's cover.
Note: only use the original battery provided by Cecotec, the use of a different one could cause
product damage.

7. TROUBLESHOOTING

Error Reason
The power
1 switch is off
while charging
Solution
Check if the power
switch is on or off and
turn it on
Button display
The robot's display
flashes quickly
ENGLISH
Beeps
1 long beep
35