Operation; Jog/Shuttle Search - Sony DSRM-10 Manual De Instrucciones

Operation

Operation
The tape transport buttons of this unit function the
same as those on the recorder or player. Recording,
playback, fast forward, rewind and pause can be
remotely controlled from this unit.

Jog/Shuttle Search

Using the search dials, a search operation can be
performed in either jog or shuttle mode.
Jog mode: The speed of playback is determined by
the speed of turning the jog dial, in the range from
–2 to +2 times normal speed.
Shuttle mode: The speed of playback is determined
by the position of the shuttle dial, in the range
from
–16 to +16 times normal speed. When the shuttle
dial is in its center position, a still image is
obtained.
The speed ranges in jog and shuttle modes may depend on
the type of recorder or player connected. Refer to the
operating instructions for the recorder or player.
Note
When operating immediately after the power is turned
on, be sure to first return the shuttle dial to its center
position.
REMOTE connector or
CONTROL S connector
1
2-
2-
DSRM-10
12
1)
2)
1
Press the JOG/SHUTTLE button to activate jog/
shuttle mode.
The JOG/SHUTTLE indicator lights.
2
To search in jog mode
1) Set the shuttle dial to the center click position.
2) Turn the jog dial.
Each time you turn the jog dial by a discrete
amount, this jogs the playback one frame at a
time, either forward or backward.
To search in shuttle mode
Turn the shuttle dial.
A playback image appears at the speed according
to the angle of the dial rotation. When the dial is
set at the center click position, the tape stops and
still image is obtained.
To exit from jog/shuttle mode
Press any tape transport button.
The JOG/SHUTTLE indicator goes off, and the
recorder or player changes to the operation
corresponding to the pressed button.