VOX electronics DBL-5007 Manual De Usuario página 5

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 28
Fabric
Silk
Wool
Cotton, linen
STEAM IRONING
Place the iron in a vertical position and set the temperature control dial at the minimum/low
heat setting.
Insert the plug into the socket, and then turn the temperature control dial to the "high heat"
marking. The pilot light will come on, indicating that the iron is heating up.
When the pilot light turns off, the set temperature has been reached and the iron is ready to
use.
During ironing, the pilot light on the iron automatically switches on/off as the thermostat
maintains the set temperature(you may continue ironing during this process).
Turn the steam control turning knob to the required position.
Steam is produced as soon as the iron in held horizontally.
SPRAYING
Press the spray button to spray water on clothes, as often as required.
Note: When using the water spray function, ensure that there is enough water in the water tank,
and you may have to pump the spray button serval times at first time you use the iron in order to
start the spraying function.
BURST OR VERTICAL STEAM IRONING
Press the burst of Steam button to generate a powerful burst of steam that can penetrate the
fabrics and smooth the most difficult and tough creases. Wait for a few seconds before
pressing again.
By pressing the Burst of Steam Button at intervals you can also iron vertically (curtain,hung
garments, etc.)
Note: The burst steam function can only be used at high temperature. Stop the emission when the
pilot light turns on, then start ironing again only after the pilot light has turned off.
DRY IRONING
For ironing without steam, follow the instruction in section "steam ironing", however, the steam
control turning knob should remain in position "OFF" (no steam).
HOW TO CLEAN AND STORE
After using, lift the iron with the filling hole downwards to empty the remaining water from the
Water tank.
Insert the plug into the socket, and set the Temperature Control Dial to "MAX" for 1-2 minutes
to evaporate the remaining water, and then unplug the iron and let it cool down before storing
it.
Temperature control
●●
●●●
3
Temperautre requirement
Low temperature
Medium temperature
High temperature

Publicidad

Tabla de contenido
loading

Tabla de contenido