Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
WARNINGS
•
After unpacking, packing and protection materials should be discarded.
•
Check before each use that the parts are safe and tight.
•
If the parts are not installed correctly, it can be dangerous!
•
The maximum weight of the child is 25 kg and only for one child. Forbid being overload, or this will lead to injury the child.
•
Avoid environments of excessive humidity, cold or heat.
•
Avoid obstacles with which the tricycle can collide.
•
To prevent rust, use natural oil polish on the welded parts.
•
Dispose of plastic bags, children should not play with them as they pose a choking hazard.
•
This product has two purposes:
a. Children can push the tricycle for themselves.
b. The children put their feet in the footrest and an adult pushes the tricycle.
•
The product must be used with caution and skills are required to prevent falls or collisions that may cause injury to the user or third
parties.
PRECAUTIONS AND POINTS OF CONSIDERATION:
•
The product is suitable for children from 12 months to 36 months.
•
Before using, read the instructions carefully and save them for future reference.
•
Keep it away from the re.
•
Must be assembled by an adult, and the child should always have the supervision of a caregiver.
•
This product is not for playing on the roads.
•
When the tricycle is used with the push :, the child must put the feet on the footrest.
•
Protective equipment should be worn (helmet, gloves, knee-pads and elbowpads).
•
Do not use this product if any part of it is worn, broken, broken or missing. Please use parts approved by your manufacturer only.
EN 71-1:2014;
EN 71-2:2011+A1:2014;
EN 71-3:2013+A2:2014;
I.PARTS: 1. Frame 2. Backrest; 3. Canopy; 4. Handle Bar; 5. Seat; 6. Front wheel; 7. Rear wheel; 8. Push bar upper; 9. Push bar lower;10.
Basket bag; 11. Head light; 12. Footrest; 13. Front fork; 14. Safety guard; 15. Foldable footrest; 16. Cup holder; 17. Fender; 18. Bushing;
19. Screw; 20. Tools.
II. ASSEMBLY THE TRICYCLE
1. Insert the Fender (Q) and bushing (R) into front fort (M) then tighten them up with screw. Please follow the mark of
fender when install.
2. Take front wheel (F) insert the assembled front fork and use tool (T-3,T-4) xed the screws.
3. Take the assemabled front wheel insert the frame (A).
4. Use tool (T-3) install and xed the handle bar (D).
5. Insert the screw (S) into the real wheel (G) then install to frame (A).
6. Take o the screw and plastic on the middle foot rest (N), then insert the foot rest into the frame,last tighten them up with screw and
plastic.
7. Use tool (T-4) to ghten backrest (B) and seat (E) up with screw.
8. Install the model C buckle on safety belt of seat (E).
9. Insert the seat (E) onto the frame (A) then heard "click"
10. Assemble the safety guard (N) on the frame and use tool (T-4) to ghten them up with screws (T-2).
11. Insert the pushbar upper(H) into the pushbar lower(I) then install into the frame(A).
12. Insert the canopy(C) into the backrest(B)
ENGLISH
Publicidad
Tabla de contenido
