Technics SU-R1000 Instrucciones De Funcionamiento página 16

Operations
Using turntable
PHONO cable (not supplied)
PHONO earth lead
(not supplied)
: The illustration shows the example when
*
connecting with PHONO cable. You can also
connect the device with PHONO-XLR cable.
1 Disconnect the AC mains lead.
2 Connect this unit and a turntable.
• Remove the PHONO short pins when
connecting to the analogue audio input
terminals (PHONO).
• PHONO terminals for connecting the
turntable supports MM/MC type cartridge.
(PHONO XLR terminals only supports MC
type cartridge.)
3 Connect the AC mains lead to this unit.
( 12)
4 Press the unit on/off button to the
[ ] position.
5 Press [PHONO-XLR] or [PHONO] to
select "PHONO XLR"/"PHONO".
• You can also select the input source by
turning the input selector knob on the unit.
6 Start playback on the connected
turntable.
• When connecting a turntable with a built-in
PHONO equaliser, use the analogue audio
cable to connect to the analogue audio input
terminals (LINE1 or LINE2) of this unit. ( 15)
• When connecting a turntable with a PHONO
earth lead, connect the PHONO earth lead to
the PHONO EARTH terminal of this unit.
16
(16)
Select the settings (MM/MC) to fit the cartridge
type of the connected turntable.
1 Press [MENU].
2 Press [ ], [ ] repeatedly to select
*
3 Press [ ], [ ] to select "MM"/"MC"
• Not available when "PHONO XLR" is selected as
• When "MM/MC" is adjusted, "Cartridge
Turntable
If sound distortion occurs or the input level is low
when using the analogue audio input terminals,
adjusting the gain may improve the sound
quality.
1 Press [MENU].
2 Press [ ], [ ] to select "Gain" and
3 Press [ ], [ ] to adjust and then press
• When "Gain" is adjusted, "Cartridge Optimiser"
This unit measures and optimises the crosstalk
and frequency characteristics of cartridge by
playing the supplied calibration record on the
connected turntable.
• Depending on the "Cartridge Optimiser"
■
• Connect the PHONO earth lead of the turntable
• Set "MM/MC" of this unit in accordance with
• Set "Gain" of this unit in accordance with the
Selecting the cartridge type
"MM/MC" and then press [OK].
and then press [OK].
input source. (The setting is fixed to "MC".)
Optimiser" is fixed to "Off". Set "Cartridge
Optimiser" again or select the registered data
correspond with "MM/MC". ( 17)
Adjusting the audio input level
then press [OK].
[OK].
is fixed to "Off". Set "Cartridge Optimiser"
again or select the registered data correspond
with "Gain". ( 17)
Optimising the character of
cartridge
setting, "REC OUT" turns to "Off" and the
sound does not output from the analogue
output terminals (REC OUT).
Prepartion
to the PHONO EARTH terminal of this unit.
the cartridge type of the turntable.
cartridge of connected turntable.