Technics SU-R1000 Instrucciones De Funcionamiento página 19

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 134
Do not input the audio signal from REC
OUT/PRE OUT terminals to the analogue
audio input terminals of this unit. Doing so
may cause malfunction.
Connecting a power amplifier,
subwoofer, etc.
You can connect the power amplifier, subwoofer,
etc. with analogue audio cable (not supplied) to
output the analogue audio signals.
Analogue audio cable
(not supplied)
AUDIO IN
1 Disconnect the AC mains lead.
2 Connect this unit and a power
amplifier, subwoofer, etc.
3 Connect the AC mains lead to this unit.
( 12)
4 Press the unit on/off button to the
[
] position.
Note
• For details, refer to the operating instructions of
the connected device.
• The audio signal output from the power
amplifier, subwoofer, etc. connected to PRE
OUT terminals can be enable/disable. ( 21)
Using analogue audio input device
Power amplifier,
Subwoofer, etc.
Connecting a recording equipment
When connecting a recording equipment to this
unit, use the analogue audio cable (not supplied)
and connect REC IN terminal with the audio
output terminals of the connected equipment,
connect REC OUT terminals with the audio input
terminals of the connected equipment.
• Press [REC IN] to switch the input source to
"REC IN".
Analogue audio cable
(not supplied)
Recording input
termials
Recording equipment
(REC IN, AUX IN)
1 Disconnect the AC mains lead.
2 Connect this unit and a recording
equipment.
3 Connect the AC mains lead to this unit.
( 12)
4 Press the unit on/off button to the
[
] position.
Note
• The choppy audio occurs in output audio signal
when switching the input source.
• The audio signal output from recording
equipment connected to REC OUT terminals
can be enable/disable. ( 21)
AUDIO OUT
19
Operations
(19)

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido