Imetec N9701 Instrucciones De Uso página 26

•
After treatment, carefully wash the treated area, dry and if
necessary, apply cream, gel or lotion without alcohol or irritants.
ROLLER FOR NAILS
EN
The roller for nails is made up of two parts with separate functions:
the lilac-coloured part is for smoothing the nail surface, the white part
is for polishing it.
•
Cut and file the nails as usual, wash and dry carefully.
•
Assemble the roller for nails (1C) on the body of the appliance
and turn the appliance on as described in the paragraph above.
•
Without exerting excessive pressure, slide the smoothing half
of the roller (lilac) on the surface of the nail for no longer than 2
seconds per nail.
•
Without applying excessive pressure, and for no longer than
2 seconds per nail, slowly slide the polishing half of the roller
(white) on the surface of the nail.
•
Rinse the nails under water to remove the residues and dry
them thoroughly.
REPLACING THE HEAD WITH ROLLER
•
The roller is made of delicate materials: handle it with care!
ATTENTION! Only use the roller on clean and dry
nails.
ATTENTION! Using a broken or ruined roller can harm
the skin. Replace the roller (1A, 1B, 1C) when the
result is not satisfactory. The frequency at which it is
replaced varies according to the frequency of use and
the extent of the treated areas.
24