Circuit Breaker Instructions; Auger Grabbing Stomper Instructions - Weston PRO Serie Instrucciones De Montaje

CIRCUIT BREAKER INSTRUCTIONS

This Grinder is equipped with a Circuit
Breaker as a safety precaution. If the Grinder
stops running follow these steps to remedy:
1. Turn the Grinder to the "Off" position.
2. Check the Grinder to see if there is a jam in
the Grinder Head. If there is, the jam needs
to be cleared of the obstruction as outlined in
"Grinding Tips".
3. Press the Circuit Breaker Reset Button
(FIGURE 13).
4. Turn the Grinder back on and resume
grinding.
5. If the Grinder still does not turn on, check that the electrical wall outlet is
properly working. Plug in another appliance to see if that appliance works from
the wall outlet. Check that the household circuit breaker has not been tripped. If
none of the above steps remedy the situation, or if the Circuit Breaker repeatedly
shuts off the Grinder contact a customer service for further assistance.
WARNING! DO NOT continue to use the Grinder if the Circuit Breaker trips
repeatedly. Continued use may cause permanent damage to the Grinder and
will void the warranty.
PLEASE NOTE: This Grinder features an all hardened steel gear
transmission. This causes the Grinder to operate at a higher volume and
temperature than other Grinders. This is normal and will not affect the
Grinder's performance.
GRINDING TIPS
. DO NOT over-tighten the Front Ring Nut. It should be firmly tight.
. Make sure the Grinding Knife blades lay flat on the Grinder Plate.
. DO NOT operate the Grinder without meat in the Head. Running the
Grinder while dry could damage the Head and Auger.
. ALWAYS lubricate the Head, Grinding Plate and Grinding Knife with a food-
grade silicone spray after cleaning.
. If the Grinder Plate becomes jammed/clogged during operation, follow these
steps to restore normal output.
. Turn the Grinder "OFF" and disconnect the Power Cord from the electrical outlet.
. Remove the Front Ring Nut and Grinding Plate.
. Thoroughly clean the Grinding Plate. Make sure all of the holes are clear.
. Re-install the Grinding Plate and Front Ring Nut.
. Re-connect the Grinder to the electrical outlet.
Continue with grinding.
. Repeat as necessary.
16

AUGER GRABBING STOMPER INSTRUCTIONS

FIGURE 13
WARNING!
Grinder, make sure the Grinder Motor is OFF and the PLUG IS REMOVED
FROM THE OUTLET/POWER SOURCE!
To use the stomper to disassemble
the head of the meat grinder, follow
these instructions:
1. Unscrew the front ring nut.
2. Attach the handle end of the
Circuit Breaker
stomper onto the auger pin. The
Reset Button
opening on the stomper should
completely secure around the
groove in the pin (FIGURE 14).
3. Pull the stomper toward yourself,
and away from the grinder. The
auger will begin to disengage from
the head of the grinder.
4. Use the hand that is not holding
the stomper to guide the auger out
from the head completely.
5. The auger, grinder knife and
plate are all now free from the head
and can be cleaned appropriately
(FIGURE 15).
Before cleaning, assembling or disassembling the
Stomper
Auger Pin
Front Ring Nut
Auger
Knife
Plate
WARNING!
NEVER operate Grinder without the
Tray/Safety Guard secured in place.
To avoid serious or fatal injury, NEVER reach
into any Grinder inlet.
ALWAYS use the Stomper to push meat
into the Grinder Head.
Read & fully understand all instructions
& warnings prior to use.
FIGURE 14
FIGURE 15
Head
17