Publicidad
Idiomas disponibles
Idiomas disponibles
PosITIon The sUPPoRT bRAcKeTs
Above your vehIcLe'S croSSbarS.
aTTach boLTS.
Insert bolt into round hole,
and T-bolt into slotted hole.
checK InsTAllATIon:
Make sure installation is secure
by tugging at basket.
The basket should NOT
SLIDE on the bars.
Tighten knobs if
necessary.
•c onTInue To bacK page for IM po r Ta nT lo ad l I M I Ta TIo ns . . .
1031908E-3/8
• Place the brackets
oUTsIde of the basket
frame.
• Tabs on brackets must
face Inboard.
move the bracket to a new
position, or to adjust the
ATTAch The Knobs:
Engage the threads of
the bolts.
Use cAUTIon When
oPenIng your haTch.
Keep bar
below Tab!
It may be necessary to
basket position.
secURe The
bAsKeT To
The barS .
Lock the T-bolts.
TO remOve The bASkeT, dO nOT
diSASSembLe The hArdWAre.
• Loosen the knobs until barely
On some
attached.
vehicles, hatch
interference is
• unlock the T-bolts and let curved
unavoidable.
brackets swing freely.
• remove basket.
PoSITIon The cover brackeTS.
Position cover bracket onto installed
support brackets.
Hooked tab should cover the larger
support bar.
Arrow points inboard
to center of vehicle.
T-bolT Is locKed
when the "T" of the
bolt is turned inside
the hole:
TIghTen
The Knobs.
Publicidad
