Before Use - Taurus PERSEO Manual De Instrucciones

INSTRUCTIONS FOR USE

BEFORE USE:

- Make sure that all products' packaging has been removed.
- Before using this product for the first time, it is important to make a
full charge of batteries.
INSERTION OF A COMB GUIDE:
- Hold the guide comb by the two sides, insert the head into the
guides and slide downward until it is coupled. (Fig.1).
- To extract the comb guide, just pull out.
USE:
- Turn the appliance on, by using the on/off switch.
- Comb to trim beard:
- Use the guide comb from 2 mm to 6 mm according the desired
measurement. For a three-day beard use the 3 mm measurement.
(Fig.2).
ONCE YOU HAVE FINISHED USING THE APPLIANCE:
- Turn the appliance off, using the on/off switch
- Unplug the appliance from the mains.
- Clean the appliance.
CLEANING:
- Disconnect the battery charger from the mains and allow it to cool
before undertaking any cleaning task.
- Dismantle the appliance following these steps:
- Press the blades, gripping them from the sides (Fig.3).
- Clean the equipment with a damp cloth with a few drops of wash-
ing-up liquid and then dry.
- Do not use solvents, or products with an acid or base pH such as
bleach, or abrasive products, for cleaning the appliance.
- Never submerge the appliance in water or any other liquid or place
it under running water.
- During the cleaning process, take special care with the blades, as
they are very sharp.
- If the appliance is not in good condition of cleanliness, its surface