Fantic INTEGRA 150 TRAIL Manual De Uso página 95

If the quick release lever has not
been closed properly, the wheel
may shift or come loose. This may
result in hazardous riding condi-
tions, falls and accidents.
5.d - Removing the rear wheel
- Using the gear change lever, transfer the chain
to the smallest sprocket (see paragraph "2" -
Section "05") (fig. "74").
Position the bicycle so that it is stable and
-
the rear wheel is off the ground.
- Push the gear change unit forward and press
the button (t) to lock it in place (fig. "75").
The tension on the chain is released.
- Using a 6 mm wrench, unscrew the axle pin
from the brake side (fig. "76").
- Slide the axle pin out of the frame.
- Disengage the chain from the sprocket and re-
move the wheel (fig. "77").
- Insert the transport block (f - supplied) be-
tween the brake pistons (fig. "68").
Never operate the hydraulic brakes when the
wheel unit has been removed. Use the trans-
port blocks (f - supplied) and remember to re-
move them before replacing the front wheel
(fig. "68").
5.e - Mounting the rear wheel
- Remove the transport block (f) from the brake
pistons (fig. "78").
Do not operate the rear brake lever.
- Insert the wheel between the frame forks, posi-
tioning the chain on the smallest sprocket and
making sure that the brake disk is positioned
Ed. 1 - 07/2019
Cleaning and Maintenance
between the brake piston (fig. "79").
- Insert the axle pin from the brake side and
push it until it protrudes from the other end of
the wheel hub (fig. "80").
- Using a 6 mm wrench, tighten the axle pin
from the brake side (fig. "81").
- Apply the correct tightening torque to
the axle pin (see the chart at the end
of section "3").
- Push the gear change unit forward to release it
(fig. "82").
- Make sure that the wheel turns freely.
6. FLAT TYRE
- In the event of a flat tyre, first of all, attempt to
re-inflate it, if the tyre deflates again it may be
punctured or damaged.
- If you need replace a tyre we recommend you
contact your vendor or a bicycle tyre fitter.
- If you wish to repair a tyre yourself, make sure
you have the following items:
- 2 tyre levers
- A (new) inner tube having the same type of
valve and dimensions as the one to be re-
placed
- A new tyre (if necessary)
- A compatible bicycle pump
07
EN_33