Noise Development - Clatronic UM 3047 Instrucciones De Servicio

Instructions for Use
• Please cut the items that are to be mixed into small pieces
beforehand.
• Do not overfi ll! Do not exceed the maximum quantity
stated on the mixing vessel!
• Ingredients: Do not put any hot items into the mixing
vessel.
• Seal: The seal can also be used as a measuring jug
(20-100ml).
• Short-term operation: The mixer is also suitable for short-
term operation of not more than 30 seconds. After this time
it should be switched off.
• Pulse operation: Pulse operation is achieved by pressing
the button briefl y and then releasing it again. The mixture
should be used in this mode for not more than 2 minutes.
Please allow it to cool down for 2 minutes before using it
again!
Chopping up Ice Cubes: The blade in the mixing vessel is
•
also suitable for chopping up ice cubes. Please only fi ll the
carafe up to 1/2 full with ice cubes. Only the PULSE button
should be used for breaking up the ice.
Operation
Preparation
• Place the mixing vessel in position.
• Now put the ingredients that are to be mixed into the mixing
vessel (max. 1.5 litres).
• Place the lid in position and turn it to the operating position
(see illustration C).
• Close the lid with the seal.
Electrical Connection
• Ensure that the function switch is in the „0" position.
• Connect the mains lead to a properly installed 230 V, 50 Hz
safety power socket.
Mixing
• For constant mixing (continuous mode):
During operation on levels 1 to 3 the switch locks into the
respective position. The setting can be read off on the round
scale.
Level 1 = low rpm
Level 3 = high rpm
Shift the selector to „0" to switch off the appliance.
• For pulse mode (mixing at brief intervals):
shift the switch to „0" position. The switch snaps into place.
The appliance is off now. Now press the PULSE button. The
pushbutton has to be held in this position according to the
desired interval length. If the button is released the machine
switches off automatically.
Adding further ingredients to be mixed
• Please switch off the machine before doing so. Spices
or other ingredients that are to be mixed can be inserted
through the hole in the seal.
26
05-UM 3047 26
Stopping Operation
• Turn the switch to the „0" position.
• In order to remove the mixing vessel, turn it in a clockwise
direction to the symbol .
• To pour out the contents, turn the lid a short distance to the
symbol . Or if required, select the sieve opening
Mains Cable Take-up Device
The mains cable can be wound up on the base.
Cleaning
Preliminary Cleaning
• Half fi ll the mixing vessel with water and press the PULSE
button fur approx. 10 seconds. Then pour out the liquid.
• Remove the mains plug from the socket.
For thorough cleaning, please remove the mixing vessel.
• Any removable parts which have come into contact with
food can be cleaned in soapy water.
• Diffi cult-to-remove items in the mixing bowl can be removed
with a rinsing brush. Please take care with the sharp knives!
• The housing of the motor device can be wiped off with a
slightly moistened cloth. Do not immerse the motor device in
water!
• Dry all parts with a dry towel after washing.
• For the purposes of storage, wind up the cable and reattach
all the parts to the motor housing.
Dishwasher
None of the components are suitable for cleaning in the
dishwasher!
Troubleshooting
• Device is not working.
Remedy:
Check the mains connection.
Check the position of the rotary switch.
Other possible causes:
The device is fi tted with a safety switch.
This prevents the motor from starting up unintentionally.
Remedy:
Check that the mixing vessel and lid are properly installed.

Noise development

The sound pressure level in the ear of an operator (LpA) was
measured according to DIN EN ISO 3744.
Sound pressure level detected: 85.0 dB(A) (no limit)
.
31.07.2006, 12:24:56 Uhr