Interface Installation - OHAUS RS232 Manual De Instrucciones

EN-2

INTERFACE INSTALLATION

Plug the USB connector into any upstream USB port, such as a USB port on your
computer. Windows will automatically detect the kit and begin installing the driver.
When Windows finished installing the driver for the interface kit, it will detect a new
COM port. Another RS232 connector of the kit can be plugged into the female
RS232 connector on the balance.
1.
Example of Windows XP Hardware Wizard
2. After clicking Finish, the virtual port should be ready for use.
Windows® typically adds the virtual port in sequence after the highest number
COM port. For example, on PC's equipped with up to 4 COM ports, the virtual
port will be COM5.
When using the USB interface with programs that limit the number of COM port
designations, it may be necessary to assign one of these port numbers to the new
virtual port. This can be done in the Port Settings of the Device Manager utility,
found in the Windows Control Panel.
RS232-USB Interface