Interface Installation - OHAUS RANGER 7000 Manual De Instrucciones

Ethernet Interface
INTRODUCTION
This Ethernet interface kit is for use with the Ranger
KIT CONTENTS

INTERFACE INSTALLATION

Only one interface module can be installed in the terminal option slot at a given time.
Install the Ethernet Interface on the underside of the balance as shown.
1. Release the two screws, remove the red interface options cover, and unplug the black rubber insert.
2. Install the Interface PCB. Push it through the pins and secure it with the 3 screws.
Pins
d Quality Products Online at:
 Pressure button
 Screws (5)
Cord groove
Screws
GlobalTestSupply
www.
®
7000 scales.
 Cable
 Ethernet PC Board
.com
EN-1
sales@GlobalTestSupply.c