Klein Tools CL330 Manual De Instrucciones página 5

To ensure safe operation and service of the meter, follow these
instructions. Failure to observe these warnings can result in
severe injury or death.
• Before each use verify meter operation by measuring a known voltage
or current.
• Never use the meter on a circuit with voltages that exceed the
category based rating of this meter.
• Do not use the meter during electrical storms or in wet weather.
• Do not use the meter or test leads if they appear to be damaged.
• Use only with CAT III or CAT IV rated test leads.
• Ensure meter leads are fully seated, and keep fingers away from the
metal probe contacts when making measurements.
• Do not open the meter to replace batteries while the probes are connected.
• Use caution when working with voltages above 25V AC RMS or 60V
DC. Such voltages pose a shock hazard.
• To avoid false readings that can lead to electrical shock, replace
batteries when a low battery indicator appears.
• Do not attempt to measure resistance or continuity on a live circuit.
• Do not hold meter above hand & finger guard during use.
• Always adhere to local and national safety codes. Use personal
protective equipment to prevent shock and arc blast injury where
hazardous live conductors are exposed.
• Usage of this meter in any way other than that specified by the
manufacturer can impair safe operation, resulting in severe injury or death.
AC (Alternating Current)
Resistance (in Ohms)
Double Insulated Class II
Warning or Caution
Diode
Hz
Frequency
V Voltage (Volts)
°F/°C
Temperature (Fahrenheit / Celsius)
AC (Alternating Current)
Negative Reading
Auto Auto Ranging
MIN Minimum Value
Auto Power Off
APO
Audible Continuity
°F
Degrees (Fahrenheit)
M
Mega (value x 10
m
milli (value x 10
n
nano (value x 10
A
Amps
Hz/% Frequency/Duty Cycle
WARNINGS
SYMBOLS ON METER
SYMBOLS ON DISPLAY
H
MAX Maximum Value
AVG Average Value
°C
k
)
6
μ
)
-3
V
)
-9
MAX MIN
AC/DC Voltage
Audible Continuity
Ground
Risk of Electrical Shock
Capacitance
%
Duty-cycle
A Amperage (Amps)
DC (Direct Current)
Data Hold
Battery Strength Indicator
Resistance Measurement
Degrees (Celsius)
kilo (value x 10 )
3
micro (value x 10
Volts
Ohms
Max/Mix/Avg mode active
)
-6
5