Velleman CAMCOLVC10 Manual Del Usuario página 5

•
up to 150 minutes of recording time (depending on settings)
•
two pushers
•
USB 2.0 plug and play device
•
USB cable included
5.
Overview
Refer to the illustration on pages 2 and 3 of this manual.
A camera lens
B crown
C status LED
D video/power button
E USB connection port
6.
Setting/operation
Refer to the illustration on pages 2 and 3 of this manual.
Make sure the battery is fully charged (5‐6 hours) before use.
Battery charging
•
To do this, open the cover of the USB port [E] and plug the jack of the
included USB cable in.
•
Plug the USB connector into a powered USB port.
•
The status LED [C] turns red + blinking blue.
•
When charging is completed, the status LED [C] turns blue; unplug the USB
connector.
Using the wristband
•
To open the wristband, first lift the clasp protection [H].
•
Push both clasp locks [J] simultaneously and pull the clasp [I] upward.
•
To close, firmly press the clasp [I] until it snaps into place and close the
clasp protection [H].
Setting the time
•
Simply pull the crown [B] away from the housing (±1mm) and rotate until
the hands show the correct time.
•
Push the crown [B] back towards the housing to avoid accidental
adjustments.
Note: to set the time stamp of the camera, see under § Connecting to USB
port
Using the camera
•
The camera lens [A] is located between the numbers 1 and 2.
•
Switch the camera on by pressing the video/power button [D] for ±2s. The
status LED [C] will light up blue. The camera is now in standby mode.
•
Press the video button [D] shortly to start recording. The status LED [C] will
flash 3 times blue then switches off.
10/09/2010
CAMCOLVC10
F picture button
G microphone
H clasp protection
I clasp
J clasp lock (2x)
5
Rev. 01
©Velleman nv