Maintain For Performance; Storing; Troubleshooting/Repairs - Max CN238D Manual De Operaciones

Flooring material
Metal contact tip

5. MAINTAIN FOR PERFORMANCE

q DO NOT FIRE THE NAILER WHEN IT IS EMPTY
w USE A 3-PIECE AIRSET
Failure to use a 3-piece airset allows the moisture and dirt inside compressor to pass into the tool
directly. This causes rust and wear, and results in a poor operating performance. The hose length
between airset and tool should be no longer than 5 m since a longer length results in a reduction in air
pressure.
e USE RECOMMENDED OIL
The velocite or turbine oil should be used to lubricate the tool. Upon completion of operations, place 2
or 3 drops of oil into the air plug inlet with the jet oiler. (Recommended Oil : ISO VG32)
r INSPECT AND MAINTAIN DAILY OR BEFORE OPERATION
WARNING:
Disconnect air supply and empty the magazine when inspecting or maintaining the tool.
(1) Drain air line filter and compressor
(2) Keep lubricator filled in air 3-pieces set
(3) Clean filter element of air 3-pieces set
(4) Tighten all screws
(5) Keep contact arm moving smoothly

6. STORING

q When not in use for an extended period, apply a thin coat of the lubricant to the steel parts to avoid
rust.
w Do not store the tool in a cold weather environment. Keep the tool in a warm area.
e When not in use, the tool should be stored in a warm and dry place. Keep out of reach of children.
r All quality tools will eventually require servicing or replacement of parts because of wear from the
normal use.
7. TROUBLE SHOOTING/REPAIRS
The troubleshooting and/or repairs shall be carried out only by the MAX CO., LTD. authorised distributors
or by other specialists.
q Mount the metal contact tip firmly, onto the contact arm.
w Metal contact tip can be mounted with tool in horizontal or vertical position.
e Place the tool onto the flooling material as illustrated.
RUBBER CONTACT TIP FOR DRY WALL APPRICATION
13