Maintain For Performance - Max GS732C LT Manual De Operaciones Y Mantenimiento

2 Install the newly charged Battery into the Housing until it
has clicked.
(See Page 13 for the charging method)
3 Install the Fuel Cell.
(See Page 14 for the Installation method)

7. MAINTAIN FOR PERFORMANCE

1. HANDLE THE TOOL WITH CARE
Never drop, collide or hit the tool against a hard material. It
may be deformed, cracked or damaged.
2. DO NOT TRIGGER THE TOOL WITH NO PINS LOADED
If you repeatedly operate the tool with no pins loaded, the
durability of each section will be reduced.
3. DO NOT LUBRICATE THE TOOL
Never lubricate the Tool because it will cause problems.
4. INSPECT THE TOOL PERIODICALLY
In order to maintain the performance of the tool, clean and
inspect the tool periodically. To have it inspected, contact
your nearest distributor.
5. CLEAN THE AIR FILTER
Clean the Air Filter every other day. Open the cylinder cap
unit with a regular screwdriver,and clean it with Com-
pressed air.
CAUTION
• Be sure that the tool has been cool down.
6. MAINTENANCE LED INDICATOR
When the indicator light starts blinking, it is time to clean the
tool. Bring the tool to the MAX CO., LTD. authorized service
center for cleaning inside of the tool.
19
LED