Master/Slave Operation - NEO PROTON 12 HEX USB Manual De Usuario

7. MASTER/SLAVE
OPERATION
When multiple PROTON 12 HEX USB units are used to-
gether, Master/Slave mode enables the assignment of
one master unit and multiple slave units. The master unit
can be operated in stand-alone mode (i.e., auto program
or sound-active mode -- not DMX mode). The slave units
should all be set to slave mode as described below.
- Note: Slave units should be configured and connected
before linking to master unit.
SETUP AS BELOW:
Slave units:
1. Press MENU button until 6-CH or 11-CH is displayed
2. Press ENTER
Set DMX address to d 1
3.
4. Connect DMX cable from master unit to DMX In con-
nector Link following slave units in similar cable configuration.
Master unit:
1. Set to Auto or Sound-Active mode
2. Link to slave units, beginning from the master DMX
Out connector.

MASTER/SLAVE OPERATION

PROTON 12 HEX USB units can operate in Master/Slave
mode wirelessly using the optional UFI wi- transceiver. The
master UFI-enabled unit can be operated in stand-alone
mode, with the UFI set to transmit. The slave units should all
P. 12
PROTON 12 HEX USB
ENGLISH VERSION
(via UFI- WIFI)