Packing List; Installing The Handle - Husky HU80432 Manual Del Operador

 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-866-340-3912 for assistance.

PACKING LIST

Pressure Washer
25 ft. High Pressure Hose
Trigger Handle
Spray Wand
Quick-Connect Nozzle (3)
Soap Blaster™ Nozzle
Turbo Nozzle
Injection Hose with Filter
Wheel (2)
Flat Washer (2)
Axle (2)
Hitch Pin (2)
4-Cycle Engine Oil (SAE 30 or SAE 10W30)
Handle
Nozzle Holder with Spring Clip
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Failure to heed this
warning could result in serious personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
ATTACHING THE WHEEL ASSEMBLY
See Figure 2.
 Locate the axle, hitch pins, washers, and wheels. Remove
the hitch pin from the axle.
 Slide the axle through the hole in the center of the
wheel.
 Slide the washer onto the axle.
 Lift the machine and slide the axle into the wheel mount-
ASSEMBLY
ing hole in the machine base as shown.
 Push the hitch pin into the hole on the end of the axle to
secure the wheel assembly.
NOTE: The hitch pin should be pushed into the axle until
the center of the pin rests on top of the axle.
 Repeat with the second wheel.

INSTALLING THE HANDLE

See Figure 3.
 Push and hold the button on the handle as you slide the
handle into the holes in the frame.
NOTE: Before use, pull the handle up until the lock
button snaps through the locking slot to secure the
handle in place.
ADDING LUBRICANT TO THE ENGINE
See Figure 4.
NOTE: This machine has been shipped with approximately
2 oz. of lubricant in the engine from testing. You must add
lubricant to the engine before starting it the first time.
CAUTION:
Any attempt to start the engine without adding lubricant
will result in engine failure.
 Place pressure washer on a flat, level surface.
 Unscrew the oil cap / dipstick by turning counter-
clockwise.
 Using 4-stroke engine lubricant (SAE 30 or SAE 10W30),
fill to the upper level of the oil filler neck (18 oz., 4-cycle
engine lubricant provided).
 Replace the oil cap / dipstick and securely tighten.
NOTE: This engine has a total lubricant capacity of .58 qt.
ADDING GASOLINE TO THE FUEL TANK
See Figure 5.
WARNING:
Gasoline and its vapors are highly flammable and
explosive. To prevent serious personal injury and property
damage, handle gasoline with care. Keep away from
ignition sources, handle outdoors only, do not smoke
while adding fuel, and wipe up spills immediately.
When adding gas to the pressure washer, make sure the unit
is sitting on a flat, level surface. If the engine is hot, let the
pressure washer cool before adding gas. ALWAYS fill the
fuel tank outdoors with the machine turned off.
NOTE: Use unleaded gas only. DO NOT mix lubricant with
gas.
 Before removing the fuel cap, clean the area around it.
Remove the fuel cap.
8 — English