Operation - Husky HU80432 Manual Del Operador

WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear safety goggles or safety glasses with side
shields when operating power tools. Failure to do so could
result in objects being thrown into your eyes, resulting in
possible serious injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
WARNING:
Never direct a water stream toward people or pets, or
any electrical device. Failure to heed this warning could
result in serious injury.
APPLICATIONS
You may use this product for the purposes listed below:
 Removing dirt and mold from decks, cement patios, and
house siding
 Cleaning cars, boats, motorcycles, outdoor furniture, and
grills
STARTING AND STOPPING THE PRESSURE
WASHER
See Figures 11 - 12.
CAUTION:
Do not run the pump without the water supply connected
and turned on.
Before starting the engine:
 Connect all hoses.
 Check all fluids (lubricant and gas).
 Turn on the garden hose then squeeze the trigger to
relieve air pressure; hold the trigger until a steady stream
of water appears.
To start the engine:
 Turn the fuel valve to the ON position.
 Put the engine switch in the ON position.
 Pull choke.

OPERATION

 Grasp the recoil starter and pull slowly until resistance is
felt. Give the recoil starter a short, brisk pull to start the
engine.
NOTE: If engine does not start after several pulls, depress
trigger to release pressure then repeat normal starting
procedure.
Do not allow the recoil starter to snap back after starting;
return it gently to its original place.
 Let engine run for several seconds, then push choke in.
To stop the engine:
 Put the engine switch in the OFF position.
 Turn the fuel valve to the OFF position.
 Shut off the water supply and pull trigger to release
water pressure.
WARNING
Hold the handle and wand securely with both hands. Ex-
pect the trigger handle to move when the trigger is pulled
due to reaction forces. Failure to do so could cause loss
of control and injury to yourself and others.
USING THE SPRAY WAND TRIGGER
See Figure 13.
 Pull back and hold the trigger to operate the pressure
washer.
 Release the trigger to stop the flow of water through the
nozzle.
To engage the lock out:
 Push up on the lock out until it clicks into the slot.
To disengage the lock out:
 Push the lock out down and into its original position.
For the most effective cleaning, the spray nozzle should be
between 8 in. and 24 in. from the surface to be cleaned. If
the spray is too close it can damage the cleaning surface.
SELECTING THE RIGHT QUICK-CONNECT
NOZZLE FOR THE JOB
See Figure 14 - 15.
Before starting any cleaning job, determine the best nozzle
for the job. Each of the nozzles has a different spray
pattern. The nozzle patterns are: 40˚ (for gentle rinse), 25˚
(for general purpose or large surfaces), 15˚ (for tough jobs),
0˚ (for spot cleaning or high hard-to-reach areas), and the
Soap Blaster™ nozzle (for long and short range detergent
application). The turbo nozzle gives up to 50% more clean-
ing power.
10 — English
: