Blade Attachment; Electrical Connections - Faro Barcelona GALÁPAGO Manual De Usuario

INSTRUCCIONES DE SEGURIDAD / INSTRUCTION DE SÉCURITÉ / SAFETY INSTRUCTIONS / INSTRUÇÕES DE SEGURANÇA / SICHERHEITSHINWEISE /
VEILIGHEIDSINSTURCTIES / INSTRUZIONI DI SICUREZZA / ΟΔΗΓΊΕΣ ΑΣΦΑΛΕΊΑΣ / ИНСТРУКЦИИ ПО ТЕХНИКЕ БЕЗОПАСНОСТИ
HUGGER STYLE
Fasten the canopy to the top of the fan motor housing with 3 screws
provided. Hanger the canopy from the tab on the hanger bracket. This
will allow you to make the electrical connections without having to
hold the fan up. Make the wire connections. Put 2 screws in the
hanger bracket, leaving them partially out. Place the canopy up on the
hanger bracket by inserting the slotted opening of the canopy on the
screws. Insert the remaining screws through the remaining canopy
holes and tighten all 4 screws

BLADE ATTACHMENT

ELECTRICAL CONNECTIONS

galápago ref. 33301, 33302
Attach the fan blades to the blade arm. The 3 small screw should be used
to attach each blade to the blade arm with trim. Remove the 6 screws
from the underside of the fan motor and switch housing assembly and
use these to attach the blade arm and blade to the motor housing.
Tighten the screws securely.
faro 15