X-LITE X 502 Ultra Puro Seguridad E Instrucciones página 18

6. Disassembly of the inner expanding foam padding of the cheek pads
To make it easier to wash the inner comfort padding components, the cheek pads of
the helmet are fitted with inner expanding foam padding that can be removed from
the fabric lining. To remove the padding, proceed as follows after removing the cheek
pads from the helmet (see instructions above).
6.1. Unhook the three eyelets of the rear frame of the left cheek pad next to the two
hooks "A" (top and front) and snap button "D" (rear) on its back, respectively (Fig. 8).
6.2. Take the top "B" and bottom "C" flaps of the frame out of the respective loops
on the back of the frame (Fig. 8).
6.3. Gently remove the inner expanding foam padding from the fabric lining of the
cheek pad (Fig. 9).
6.4. Repeat these steps with the right cheek pad.
7. Disassembly of the chin strap covering
To remove the chin strap covering from the strap, proceed as follows after removing
the cheek pads from the helmet (see instructions above).
7.1. Pull the left covering strap in line with the "hook and loop fastener" to separate
it from the chin strap band and then take it off (Fig. 10A).
7.2. Repeat these steps with the right covering strap.10C
8. Liner disassembly
8.1. Pull the back of the comfort padding towards the inside of the helmet to un-
hook the two side buttons on its back from their seats on the rear support fixed
to the polystyrene inner shell (Fig. 11).
8.2. Unhook the left front flap from the support fixed to the inner shell below the trim
of the upper edge of the shell by slightly pulling the comfort padding towards
the inside of the helmet (Fig. 12). Repeat the same steps for the central front
and right front flaps.
8.3. Completely remove the comfort padding from the helmet.
9. Liner Assembly
9.1. Properly insert the comfort padding into the helmet.
9.2. Slip the left front flap of the liner into its seat by slightly deforming the upper
shell sealing edge (Fig. 13). Repeat the same steps for the central front and
right front flaps.
9.3. Correctly turn up the shell sealing edge and press downwards in line with the
three front flaps (left, central and right) until they are fully fastened to the sup-
port. Make sure that the front helmet area is as shown in Fig. 14.
9.4. Fasten the two side buttons on the back of the rear part of the comfort padding
to the corresponding seats on the rear support fixed to the polystyrene inner
shell (Fig. 11).
9.5. Spread out the inner comfort padding and make it stick to the inner shell by ap-
plying pressure first in the upper zone, so that the hook and loop fastener strap
on the top of the inside of the shell grips, and then along the circumference.
18