X-LITE X 502 Ultra Puro Seguridad E Instrucciones página 22

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 50
The "READY FOR CAMEL BAG" strap and the deformable seat "B" are on both sides
of the helmet.
If you do not use a hydration system, we recommend removing hose clip "A" (see
instructions below) and positioning the "READY FOR CAMEL BAG" straps behind the
pads of the removable cheek pads. To do so, pull the bottom part of the pad of the left
cheek pad upwards to release brackets "C" and "D" from the corresponding plates
between the outer shell and the polystyrene cheek pad (Fig. 21).
Then place the "CAMEL BAG" strap against the polystyrene cheek pad (Fig. 22).
Afterwards insert brackets "C" and "D" in the corresponding plates between the outer
shell and the polystyrene cheek pad, then press until they are fastened (Fig. 21).
Repeat these steps with the right cheek pad.
15.
Hydration system hose assembly
To fasten the hydration system hose, slightly buckle the free part of side hose clip
"A" and put the hose inside it. Then buckle seat "B" of the inner chin guard and
insert the initial part of the hose with the suction valve inside it. Adjust the length
of the hose by sliding it into housings "A" and "B" and continue to assemble the
hydration system following the relevant instructions and recommendations provided
by its manufacturer.
16.
Hydration system hose disassembly
To disassemble the hydration system hose, slip off its initial part by buckling seat "B"
of the inner chin guard. Then remove the hose from side hose clip "A" while buckling
it slightly.
17.
Hose clip disassembly
To remove fastening side hose clip "A" from the "READY FOR CAMEL BAG" strap,
buckle its side parts and remove them from the strap (Fig. 23).
18.
Hose clip assembly
To assemble side hose clip "A" on the "READY FOR CAMEL BAG" strap, insert first
one and then the other deformable side part of the clip under the "READY FOR CAM-
EL BAG" strap until they are completely fastened while taking care to position the free
and deformable fastening part of the hose facing upward (Fig. 20).
WARNING
-
Do not use for any reason the "READY FOR CAMEL BAG" straps and/or the
hose clip for any purpose other than those described above.
-
Always check that the side hose clip does not become entangled with clothing
or obstructs movement of the head and helmet, which must always be free.
Verify this by wearing all your clothing, including any neck and/or body braces
and protectors normally used in off-road sports. If necessary, remove the side
hose clip from the helmet.
22

Publicidad

Tabla de contenido
loading

Tabla de contenido