X-LITE X 502 Ultra Puro Seguridad E Instrucciones página 20

12.8. Repeat these steps with the right cheek pad.
Warning: the buttons are not hooked until a click is heard. Check that the strap
comes out properly from the cheek pad padding.
WARNING
- If your helmet is equipped with the double D-Ring retention system, pull it
down as indicated in the attached double D-Ring label.
- Remove the inner comfort padding only when cleaning or washing is required.
- Never use the helmet if all parts of the inner comfort padding have not been
correctly and completely reassembled.
- Delicately hand-wash in lukewarm water (max. 30° C) and neutral soap.
- Rinse with cold water and allow drying at room temperature, away from direct
sunlight.
- Never machine-wash the inner comfort padding.
- The inner polystyrene is an easily deformable material. It is apt to change or get
partially destroyed to help absorb shocks.
- Do not modify or alter the helmet's internal polystyrene components in any way.
- Clean the inner polystyrene components with a damp cloth only and allow it to
dry at room temperature away from direct sunlight.
- Never use tools or equipment of any sort to carry out the steps described
above.
EYEWEAR ADAPTIVE
13. Creating space for glasses
13.1. Remove the left cheek pad from the helmet (see instructions above).
13.2. Unhook the rear frame eyelet of the cheek pad in line with the top hook "A"
shown on its back (Fig. 16).
13.3. Take the top flap "B" of the frame out of the loop on the back of the frame (Fig. 16).
13.4. Gently remove the inner expanding foam padding from the fabric lining of the
cheek pad (Fig. 17).
13.5. Remove the upper part of the inner pre-punched padding (Fig. 17), then cor-
rectly put back the remaining padding part in the cheek pad.
NOTE: it is recommended to keep the removed padding for any subse-
quent reuse.
13.6. Put the top flap "B" of the frame back in the loop on the back of the cheek pad
and refasten the eyelet in line with the top hook "A" on the back (Fig. 16).
13.7. Refit the complete cheek pad on the helmet (see instructions above).
13.8. Repeat these steps with the right cheek pad.
14. Removing space for glasses
14.1. Remove the left cheek pad from the helmet (see instructions above).
14.2. Unhook the rear frame eyelet of the cheek pad in line with the top hook "A"
shown on its back (Fig. 16).
20