X-LITE X 502 Ultra Puro Seguridad E Instrucciones página 19

10. Assembly of the chin strap covering
The right and left chin strap covering are different from each other (Fig. 10B).
10.1. After identifying the left covering strap, insert the release mechanism of the
chin strap inside of it in line with the free end of the "hook and loop fastener"
until it comes completely out from the central slot. Press the free end of the
strap over the chin strap band in line with the "hook and loop fastener" and pull
the strap to stretch it out completely (Fig. 10A).
10.2. Repeat these steps with the right covering strap.
10.3. Make sure the straps are secured by gently pulling them towards the inside of
the helmet.
10.4. If the release mechanism is the D-Ring type, check that the anti-fluttering snap
button on the left strap only is correctly placed past the two D-rings (Fig. 10B).
11. Assembly of the inner expanding foam padding of the cheek pads
11.1. Gently put the inner expanding foam padding inside the fabric lining of the left
cheek pad (Fig. 9). Carefully spread out the padding while checking that there
are no wrinkles in the cheek pad fabric lining.
11.2. Insert the upper "B" and lower "C" flaps of the frame in their loops on the back
of the frame (Fig. 8).
11.3. Hook the three eyelets of the rear frame of the left cheek pad near the two "A"
hooks (top and front) and snap button "D" (rear) on the back (Fig. 8).
11.4. Repeat these steps with the right cheek pad.
Warning: the rear eyelet with its snap button "D" has a shape different from
that of the front and top eyelets and of the corresponding hooks "A".
12. Cheek Pad Assembly
12.1. Take the pad of the left cheek pad and check that the safety lever on the back
is in the opening position (Fig. 15).
12.2. Put the left cheek pad inside the helmet and insert the rear bracket "B" in the
corresponding plate between the outer shell and polystyrene cheek pad by
pressing until it is fastened (Fig. 7).
12.3. Insert the chin strap in the passageway of the cheek pad padding and press
near the rear snap fastener placed on the back to fasten it to the relevant seat
on the polystyrene cheek pad (Fig. 6).
12.4. Press the pad of the left cheek pad against the polystyrene cheek pad and at the
same time turn it inwards to fasten the front and top hooks on its back. (Fig. 5).
12.5. Press the safety lever upwards in line with the fastening area of the red strap to
turn it towards the cheek pad padding until it reaches its closing position. (Fig. 4).
12.6. Check that the fastener and hooks are firmly fastened by slightly pulling the
pad of the cheek pad towards the inside of the helmet, then check that it re-
mains adherent to the polystyrene cheek pad.
12.7. Insert front bracket "A" in the corresponding plate between the outer shell and
polystyrene cheek pad, then press it until it becomes fastened (Fig. 7). Place
the front red strap against the inner surface of the chin guard.
19