Functional Description - Makita DVC560 Manual De Instrucciones

Removing the filter bag
CAUTION:
Handle the filter bag softly.
Otherwise foreign objects are blown into eyes, it may
result in personal injury.
Replace the filter bag when it becomes full or clogged.
Open the dust box cover and open the latch, then take
out the filter bag.
Pull the strip on the side of the opening to shut the filter
bag and dispose of the filter bag in whole.
► Fig.11: 1. Latch 2. Strip
NOTICE:
Do not use a used filter bag. The filter
bag is designed for single use. Using filter bag repeat-
edly may cause clogging of the filter and results in
damage to the appliance.
FUNCTIONAL
DESCRIPTION
CAUTION:
Always be sure that the appli-
ance is switched off and the battery cartridge is
removed before adjusting or checking function on
the appliance.
Tool / battery protection system
The tool is equipped with a tool/battery protection sys-
tem. This system automatically cuts off power to the
motor to extend tool and battery life. The tool will auto-
matically stop during operation if the tool or battery is
placed under one of the following conditions:
Overload protection
When the tool is operated in a manner that causes it to
draw an abnormally high current, the tool automatically
stops without any indication. In this situation, turn the
tool off and stop the application that caused the tool to
become overloaded. Then turn the tool on to restart.
Overheat protection
On
When the tool is overheated, the tool stops automati-
cally, and the battery indicator blinks about 60 seconds.
In this situation, let the tool cool down before turning the
tool on again.
Overdischarge protection
When the battery capacity becomes low, the tool stops
automatically. If the product does not operate even
when the switches are operated, remove the batteries
from the tool and charge the batteries.
Indicating the remaining battery capacity
Only for battery cartridges with the indicator
► Fig.12: 1. Indicator lamps 2. Check button
Press the check button on the battery cartridge to indicate the remain-
ing battery capacity. The indicator lamps light up for a few seconds.
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
NOTE: The first (far left) indicator lamp will blink when
the battery protection system works.
Indication panel
► Fig.13: 1. Operating mode 2. Excess level of dust
Operating mode
To change the operating mode, refer to the section for switch action.
Excess level of dust
If this indicator lights up, replace the filter bag. (Refer
the section of removing the filter bag.)
Blinking
NOTE: This indicator does not work when the appli-
ance operates in "lower noise level (1)" mode.
NOTE: This indicator may not work depending on the
usage environment.
Brushroll error
Blinking
On
ance when this lamp lights up during operation.
Otherwise the motor malfunction may occur and
cause fire.
13 ENGLISH
Indicator lamps
Lighted Off
3. Brushroll error 4. Remaining battery
capacity 5. Battery check / LED lamp button
WARNING:
Immediately switch off the appli-
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
The brushroll is under high
load for some reasons.
The brushroll is stopped by
abnormal reason.