Cleaning The Brushroll - Makita DVC560 Manual De Instrucciones

Cleaning the brushroll

1. Remove the bottom plate, and then remove the
brushroll.
If the hair of the brushroll gets short, ask the Makita
service center for new one.
Operating the appliance with the short hair brushroll
results in poor dust collecting.
► Fig.32: 1. Bottom plate 2. Brushroll
2. Remove threads and hairs from the brushroll
using scissors.
Remove the cap and clean debris.
► Fig.33: 1. Cap
3.
Install the cap, brushroll, and bottom plate in
reverse order.
► Fig.34
CAUTION:
Attach the bottom plate com-
pletely. If the appliance is operated without the
bottom plate, the brushroll may come off and cause
injury.
NOTICE:
Always attach the brushroll. Operating
the appliance without the brushroll results in poor
dust collecting.
How to clear the clog
NOTICE:
Do not operate the appliance with the
intake flow path clogged. Continuous use with the
intake flow path clogged results in reduced suction
power.
1. Remove the bottom plate, and then remove the
brushroll.
2.
Remove the aluminum pipe from the appliance
and from the hose.
3. Turn the hose counterclockwise, and then remove
the hose from the appliance.
4. Remove the suction hose by pulling the tab.
► Fig.35: 1. Suction hose 2. Tab
5. Inspect the intake flow path of air for the inside of
the aluminum pipe and the hose, and the suction hose.
Clean debris inside of them.
6. Align the tongue of the suction hose with the
groove in the housing and slip it into place.
► Fig.36: 1. Tongue 2. Groove
7. Install the hose, aluminum pipe, brushroll, and
bottom plate.
CAUTION:
Install the hose, pipe firmly.
Otherwise dust leakage may occur and cause injury.
16 ENGLISH